RBUV213A
1 of 13 products in this brandRBUV213A is a single-component, low-viscosity anaerobic thread-locking adhesive with a UV-initiated surface cure component. It prevents the loosening and leaking of threaded fasteners and is ideal for preassembled components, where its low viscosity and capillary action allow it to wick into threaded assemblies. Additionally, RBUV213A can be used to fill porosity in welds and castings.
Chemical Family: Acrylate Esters
Features: Chemical Resistant, Corrosion Resistant, Heat Resistance, High Strength, Hydrocarbon Resistant, Low Viscosity, Oil Resistant, UV Curable, Vibration Resistance, Water Resistant
Enhanced TDS
Identification
- Chemical Family
- GBU
- RTU Product Type
- Categories
Applications
- Application Area
Applications & Uses
- Product Application Instructions
-
- Surfaces to be bonded should be clean and dry and free of grease. Product should be applied in enough quantity to fill all engaged threads or gap. The product performs best in thin bond gaps. Very large gaps may create gaps that will affect the cure speed and overall strength. Good contact is essential. It is recommended to confirm compatibility of the product with all substrates prior to use. This product is not recommended for use with strong oxidizing materials. Where aqueous washing systems are used to clean the surfaces before bonding, these aqueous washes can affect the cure and performance of the adhesive. This product is not normally recommended for use on plastics, users must check compatibility of the product with such substrates.
Features
- Ready-to-Use Product Features
Features & Benefits
- Features and Benefits
-
- Green Anaerobic Retaining Compound
- High Strength
- Suitable for oily surfaces
- High Resistance to Heat, Corrosion, Vibrations, Water, Gasses, Oils, Hydrocarbons, and Many Chemicals
- High temperature resistance
Packaging & Availability
- Regional Availability
Physical Properties
- Physical Form
- Appearance
-
Green liquid
Properties
- Curing Properties
-
- The rate of cure will depend on environmental conditions and the substrates used. The gap of the bond line will affect set speed. Smaller gaps tend to increase set speed. Activators may be applied to further improve set speed, but may also impair overall adhesive performance.
- Note
-
- * 7 to 72 hours at room temperature, or 40°C bondline temperature for 1 hour to achieve ≥90% of strength on steel
- Cured Properties
-
Value Units Test Method / Conditions Coefficient of Thermal Expansion* 80 ppm/K ASTM D696 Pin/ Collar Shear Strength* 20 - 32 nm ISO 10123 Service Temperature* -55 to 150 °C - Specific Heat* 0.3 kJ/kgk - Thermal Conductivity* 0.1 W/mK ASTM C177 - Specifications
-
Value Units Test Method / Conditions Consistency 1.1 - - - Uncured Properties
-
Value Units Test Method / Conditions Brookfield Viscosity (at 25°C, spindle 1, 20 rpm) 10 - 50 cPs - Flash Point min. 93 °C - Set Time on Steel (on steel) 15 - - Specific Gravity 1.1 - - Storage Condition 9 - 28 °C - - Appearance
-
Green liquid
Storage & Handling
- Storage Information
-
- Products should be stored unopened in a cool, dry place out of direct sunlight. Products may be refrigerated for improved shelf life, but should be brought back to room temperature before use.
- Shelf Life
-
13 months