ProSpec® C-1107 Construction Grout

Apply when air and substrate temperature are between 40°F (4°C) and 90°F (32°C).

•  Fluid working time 15 minutes at 70°F (21°C).
•  Agitate material as necessary within its working time to maintain workability.
•  Shut down nearby machinery prior to and during placement.
•  Provide vent holes where necessary.
•  Pour and place grout from one side of form to eliminate air voids.
•  A vibrator, rod, chain or trowel may be used to assist in consolidating the grout and eliminating air voids. Use a mixer large enough to permit continuous placement   before any part of the grout has set.
•  Confine grout to ensure minimum surface exposure. Avoid vibration for 24 hours after placement.
•  For placements greater than 3” (76 mm), extend the grout with 25 lb (11.3 kg) of washed clean SSD (saturated surface dry) 3/8” (9 mm) graded aggregate per 50 lb (22.7 kg) bag.
•  After placement, immediately trim the surfaces and edges with a trowel.
•  Minimum application thickness is 1” (25 mm).
•  Forms may be removed after grout has hardened to an initial set.

Test results obtained under controlled laboratory conditions at 73°F (22.7°C) and 50% relative humidity. More or less water may be required to achieve the desired mixing consistency depending on the atmospheric conditions and job site conditions.

This product is available in 50 lb (22.7 kg) bag

Shelf life of this product is 12 months from the date of manufacture when stored in the original, unopened container under cool, dry conditions and out of direct sunlight.