Millennium EPDM T-Joint Patch

Millennium EPDM Flashing Tapes are ideal for flashing rooftop penetrations and other details such as:

• Overlay at T-joints
• General repair in non-traffic areas

All work surfaces should be clean, dry, and free of dirt, dust, debris, oils, un-adhered coatings, deteriorated membrane and other contaminants that may result in a surface that is not sound or is uneven. If necessary, clean the surface to receive the flashing with an approved EPDM membrane cleaner.

• Not for use on PVC roof membranes.
• Not for use in high traffic areas..
• Talc, dust, oil, ice, snow, or wet conditions inhibit good adhesion.Clean and dry surfaces are necessary for proper Installation of this product.

1. Clean entire surface where Millennium EPDM T-Joint Patches will be applied..

2. Apply EPDM primer to entire surface to be covered using the supplied scrub pad. Note: Use caution when installlling at temperatures below 40°F (5°C) to prevent blushing of EPDM primer (formation of condensation on surface of primer).

3. Allow the primer to dry to the touch (no material transfer, typically less than 20 minutes). Dry time will vary depending on ambient temperature and humidity.

4. Once the primer is dry immediately install Millennium EPDM T-Joint Patches.

5. Position T-Joint Patches over primed area and remove release liner. Press down and form T-Joint Patches by hand.

6. Roll the T-Joint Patches with a 2” (5.08 cm) wide silicone roller.

7.Seal edges of T-Joint Patches detail with Millennium EPDM Edge Sealant.

Store material in original unopened packaging at temperatures between 40°F-110°F (4°C - 43°C). Shelf life is 9 months when stored as recommended.