Millennium EPDM Corner Flashing

Identification

GBU

BAS

RTU Product Type

Tape

Categories

Markets → Building & Construction → Applications → Building Envelope & Roofing → Waterproofing & Weatherproofing

Technologies → Adhesives & Sealants → Product Families → Pressure Sensitive Adhesives, Tapes & Labels → Tapes

Applications

Application Area

Pond Linings,

Waterproofing Applications,

Rooftop

Segment

Single Ply EPDM

Applications & Uses

Application Guidelines

1. Clean entire surface where Millennium EPDM Corner Flashing will be applied.
2. Apply EPDM primer to entire surface to be covered using the supplied scrub pad. Note: Use caution when installing at temperatures below 40°F (5°C) to prevent blushing of EPDM primer (formation of condensation on surface of primer).
3. Allow the primer to dry to the touch (no material transfer, typically less than 20 minutes). Dry time will vary depending on ambient temperature and humidity.
4. Once the primer is dry immediately install Millennium EPDM Corner Flashing.
5. Position Corner Flashing over primed area and remove release liner. Press down and form Corner Flashing by hand.
6. Roll the Corner Flashing with a 2” (5.08 cm) wide silicone roller.
7. Seal edges of Corner Flashing detail with Millennium EPDM Edge Sealant.

Product Applications

Millennium EPDM Flashing Tapes are ideal for flashing rooftop penetrations and other details such as:

• Overlay at T-joints, corners, pipes, and penetrations
• General repair in non-traffic areas
• Gravel stop flashing
• General purpose flashing

Surface Preparation

All work surfaces should be clean, dry, and free of dirt, dust, debris, oils, un-adhered coatings, deteriorated membrane and other contaminants that may result in a surface that is not sound or is uneven. If necessary, clean the surface to receive the flashing with an approved EPDM membrane cleaner.

Features

Ready-to-Use Product Features

Delamination Resistant,

Flexible,

Good Adhesion,

Good Strength,

High Durability,

Resistance to UV lights,

Waterproofing,

No Shrinkage,

Quick Installation

Features & Benefits

Product Features

Resistant to UV light, high heat and moisture - Long-term durability

Excellent adhesion and formability - Flashing details with proven peel & stick technology

Fast installation - Saves time and labor

No torch or liquid adhesives - Improved safety

Waterproof detail - Suitable for roofing, pond lining, and waterproofing applications

 

Packaging & Availability

Regional Availability

• North America

Packaging Information

WIDTH	LENGTH	PART #	CORNERS/CASE
7 inch (178mm)	9 inch (229mm)	ET-0557-7x9	20

Properties

Typical Properties

	Value	Units	Test Method / Conditions
Storage Temperature	4 - 43	°C	-

Storage & Handling

Storage and Shelf Life Conditions

Store material in original unopened packaging at temperatures between 40°F-110°F (4°C - 43°C). Shelf life is 9 months when stored as recommended.

Shelf Life

9 months