HB Fuller - H.B. Fuller EV Bond 440 - 2K (2 component) Adhesive

Chemical Family: Acrylics & Acrylates
Product Type: 2K (2 component) Adhesive,
Structural Adhesive
Technologies: Adhesives & Sealants
Product Families: Adhesives & Sealants — Functional Adhesives
Structural Adhesives

Ready-to-Use Product Features

Chemical Resistant,

Features and Benefits Information

This product has the following Features and Benefits;

No Surface Preparation Required
Excellent Adhesion Properties
Excellent Strength to Metals, E-Coat, Thermoplastics, Thermosets, and Engineering Plastics
High Impact Resistance
Suitable for Easy Manual and Pneumatic Dispensing
100% Reactive
Room Temperature Cure
10:1 meter-mix product for ease of application
Use on as received metal surfaces including aluminum, stainless and plated steels and forms tough, high strength bonds without surface preparation

Physical Form

Liquid

Appearance

Off white or amber viscous liquid

Cured Mechanical Properties


	Value	Units	Test Method / Conditions
Over Lap Shear Strength Carbon Steel	13.8	MPa	ASTM D1002, 25°C 50% RH
Over Lap Shear Strength Aluminum	13.8	MPa	ASTM D1002, 25°C 50% RH
Over Lap Shear Strength Nickle Coated Low - Carbon Steel Plated	19.0	MPa	ASTM D1002, 25°C 50% RH
Dielectric Strength	19.4 - 21.2	kV/mm	-
Elongation at Break	4 - 6	%	-

Cured Thermal Properties


	Value	Units	Test Method / Conditions
Thermal Service Range	-67 - 212	°F	-

Technical Data

Uncured Properties


	Value	Units	Test Method / Conditions
Flash Point	min. 200	°F	-
Open Time	18 - 23	minutes	-
Fixture Time	40 - 60	minutes	-
Cure Temperature and Time (room temperature)	24.0	hr	-

Rheological Properties

General Instructions: The product is best used at temperatures between 65°F and 80°F. Temperatures below 65°F will slow the cure speed of the material and viscosities will be higher. Temperatures above 80°F will cause the material to cure faster and viscosities will be lower. For consistent dispensing maintain temperature in the above mentioned range.

For optimum bond strength and to insure maximum performance in the finished assembly mate parts together within the specified work time of the adhesive. Make sure the bond joint has uniform coverage and that a sufficient amount of adhesive is in the bond area. It is important to have the adhesive applied, parts aligned and positioned, within the established work times for the product. To ensure maximum performance in the finished assembly parts should remain undisturbed until the fixture time is reached.

Packaging Type: Drums,
Pails
Packaging Information: EV Bond 440 is conveniently packaged in 50 ml, 490 ml, pail, and drum kits. Special packaging is available upon request.

Shelf Life: 9 months
Storage Information: Product should be stored in a cool dry place out of direct sunlight. Theshelf life of EV Bond 440 is 9 months from date of manufacture. Shelf life is based on the products being stored properly at temperatures between 55°F and 75°F. Exposure to temperatures above 75°F will reduce the shelf life. This product should NEVER BE FROZEN.

H.B. Fuller EV Bond 440