Enhanced TDS
Identification & Functionality
- Product Type
- Technologies
- Product Families
Features & Benefits
- Labeling Claims
- Ready-to-Use Product Features
- Product Highlights
- FOSTER 83-13HM ZP Adhesive is very low odor and has excellent swirl spray or extrusion capability.
- It may be applied at relatively low adhesive temperatures while still maintaining a long open time when applied to either the insulation or direct to the facing* material.
* For best results, and to avoid wrinkling with Saran or other temperature sensitive facings, apply the adhesive directly to the insulation rather than facing.
Applications & Uses
- Markets
- Applications
- Application Area
- Compatible Substrates & Surfaces
- Limitations
- To prevent charring keep insulation dust and other contaminants out of adhesive. Keep hot melt tank covered at all times and keep boxes of unused adhesive closed or in dust free storage.
- Maintain tank, hose and tip temperature below 325°F. When adhesive will not be used for extended periods of time turn off heat or reduce temperature to below 200°F. Do not leave adhesive in tank hot overnight.
Properties
- Physical Form
- Typical Properties
Value Units Test Method / Conditions Density 7.8 lbs./gal. - Viscosity (at 121°C) 9250.0 cps - Viscosity (at 135°C) 4700.0 cps - Viscosity (at 149°C) 3100.0 cps - Viscosity (at 163°C) 1575.0 cps - Viscosity (at 177°C) 1050.0 cps - Peel Strength (180 Degree, at 60 second , 75°F, 1 mil) 11.7 N/cm - Mettler Softening Point 80 - 90 °C ASTM D3461 Shear Adhesion Failure Temperature (SAFT, at 63°C, Load) 500.0 g/in² - VOC Content (Less Water) 0.0 g/l - Coverage Range 3 - 10 g/ft² - Application Properties
Value Units Test Method / Conditions Recommended Application Temperature 275 - 300 °F - Flame Characteristics
Value Units Test Method / Conditions Smoke Developed ¹ 0 Flame Spread ¹ 0 - Note
¹ - Applied to 1/4 inch (6.4mm) inorganic reinforced cement board. The flame spread may vary at different product thicknesses and/or when applied with on other substrates.
Regulatory & Compliance
- Certifications & Compliance
- Chemical Inventories
- Quality Standards
- Compliance
FOSTER 83-13HM ZP Adhesive meets NFPA 90A and 90B 25/50 requirements.
Safety & Health
- Precautionary Information
- To minimize the risk of burns we recommend the use of eye protection and protective clothing when working near a hot melt applicator.
- To minimize the risk of flammable vapors do not exceed melt temperatures above 400°F.
- Prevent the build-up of vapors.
- Extinguish all sources of ignition during hot melt use.
- For professional use only.
- Keep out of reach of children.
Packaging & Availability
- Packaging Type
- Packaging Information
FOSTER 83-13HM ZP Adhesive is packaged in convenient Zero-Pack bags of adhesive pillows. The ZP bags allow for easy addition to the hot melt tank by dropping the entire bag into the melt tank or by opening and adding individual pillows.
- Pillows
- 31 Lbs. (14 kg) / Case
- Zero Pack Bags (ZP): approx. 5.2 lbs./bag (2.4 kg/bag)