Enhanced TDS
Identification & Functionality
- Chemical Family
- Product Type
- Technologies
- Product Families
Features & Benefits
- Ready-to-Use Product Features
Applications & Uses
- Compatible Substrates & Surfaces
- Cure Method
Properties
- Physical Form
- Appearance
- Color fluorescent
- Technical Data
Value Units Test Method / Conditions Viscosity 1 - 5 cPs at 20 - 25°C, Brookfield SC4-21 Specific Gravity 1.06 - Cured Properties
Value Units Test Method / Conditions Full Cure Time 24 hours Service Temperature -55 - 95 °C - Uncured Properties
Value Units Test Method / Conditions Flash Point 85 °C Set Time 8 sec Steel Set Time 5 sec ABS Set Time 3 sec EPDM - General Instructions
Surfaces to be bonded should be clean and dry. Dispense a drop or drops to one surface only. Apply only enough to leave a thin film layer after compression. Press parts together and hold firmly for a few seconds. Good contact is essential. An adequate bond develops in less that one minute and maximum strength is attained in 24 hours. Wipe off excess adhesive from the top of the container and recap. products if left uncapped may deteriorate by contamination from moisture in the air. Because products cure by polymerization, whitening may appear on the surface of the container or the bonded materials. This will not affect adhesive performance.
Technical Details & Test Data
- Performance Range
Packaging & Availability
- Regional Availability
Storage & Handling
- Shelf Life
- 12 months
- Storage Conditions
Containers should be stored in a cool, dry, dark area. Storage temperature 15.5°C - 25°C (60°F - 77°F), without exposure to direct light or heat. Do not refrigerate.