Tuskbond EPDM Primer - 22L Canister

Preparation:

• Use in a well Ventilated Area.
• Surfaces to be bonded should be clean, dry and dust free.
• Once the hose and gun has been attached to the canister, open the valve fully. Check the connection points for leaks at this time.
• On first use, the canister may initially take a few seconds to spray correctly. Spray initially onto on a scrap surface to ensure the spray pattern is correct for the application. The trigger restrictor on the gun can be used to set the spray to the required width.

Application:

• Hold the spray gun at 90° to the surface, approximately 4-6 inches away and apply a uniform coat of primer, covering the entire surface.
• Allow the solvents to evaporate from the primer (3-5 minutes depending on ambient temperature). To know when the primer is ready, it should not transfer to a gloved hand when touched and should feel dry. 
• Once the primer is dried, it is ready to be worked on. Avoid contaminating the primed area with dust as much as possible, as this will impair performance.

• Once the canister is empty of any hazardous materials and depressurised, it can be considered as scrap metal, in accordance with the national or local waste company, under code EWC 15 01 04* (empty aerosol, non-hazardous residues).
• Canisters and aerosols that are still pressurised and contain product should be disposed of in accordance with the national or local waste company under code EWC 16 05 04* (full or partially empty aerosol).

• Protect from extremes of temperature in a controlled environment between 15 and 35°C, and away from direct sunlight. Do not stand on a cold concrete floor. Low temperatures can result in irreparable separation of the adhesive.
• Stored under the correct conditions, in original, unopened containers, the product will have a shelf life of 12 months. The adhesive will have a limited life once the container is opened.