Tuskbond C10 - 500ml Aerosol

Preparation:

• Use in a well Ventilated Area.
• Surfaces to be bonded should be clean, dry and dust free. If cleaning solvents are used, allow adequate time for drying and wipe surface with a clean cloth before applying adhesive. Shake aerosol before use.

Application:

• Hold the aerosol at approximately 70° to the surface.
• Spray adhesive from 6-8 inches away onto one or both surfaces. Apply adhesive in 4-6 inch bands overlapping each band by roughly 50%, with a double coat applied to the edges. Move at a steady pace that provides an even coat of adhesive without allowing any material to puddle. For most applications, 80-100% adhesive coverage is required for full bond strength. On porous materials, a second coat of adhesive may be necessary.
• For one-way application, let adhesive dry for 30 seconds until tacky, and then press into position.
• For two-way application, spray both surfaces and allow to dry for 1-2 minutes before bonding.
• For temporary bonding, spray one surface and allow to dry for 1-2 minutes before bonding.
• After use, invert the can and spray to clear any adhesive from the valve/button.

Protect from extremes of temperature in a controlled environment between 15 and 35°C, and away from direct sunlight. Do not stand on a cold concrete floor. Low temperatures can result in irreparable separation of the adhesive. Stored under the correct conditions, in original. Unopened containers, the product will have a shelf life of 12 months.

• Once the aerosol is empty of any hazardous materials and depressurised, it can be considered as scrap metal, in accordance with the national or local waste company, under code EWC 15 01 04* (empty aerosol, non-hazardous residues).
• Canisters and aerosols that are still pressurised and contain product should be disposed of in accordance with the national or local waste company under code EWC 16 05 04* (full or partially empty aerosol).