Enhanced TDS
Identification & Functionality
- Chemical Family
- Product Type
- Technologies
- Product Families
- Product Information
Technology / Base Two-component Methylmethacrylate (MMA) Type of Product MMA Curing Mechanism Polymerization Appearance / Color White Consistency Liquid
Features & Benefits
- Labeling Claims
- Ready-to-Use Product Features
- Key Attributes
- Permanent unitizing structural adhesive
- Matches white PVC trim boards
- Paintable, sandable
- Fills nail holes and gaps
- Meets 2009 EPA VOC & CARB requirements
- Product Highlights
- PVC TrimWelder™ Fast Cure adhesive does not require special surface preparation and does not contain any solvents.
- It will work successfully in most applications without preparation.
- It is so strong that it appears to weld the PVC together.
- This adhesive has a creamy consistency that will not foam, run or drip.
- PVC TrimWelder™ Fast Cure is a fast curing, two-component product with an open time of 4 - 7 minutes at 73°F after thorough mixing with approved mix tips.
- It will cure satisfactorily at application temperatures as low as 20°F.
Applications & Uses
- Markets
- Applications
- Application Area
- Compatible Substrates & Surfaces
- Typical Applications
Combine resin and activator in equal volume and mix thoroughly. For convenience and accuracy use pre-measured cartridges with disposable static mixers. Open time is 4 - 7 minutes at room temperature. Handling strength within approximately 10 - 30 minutes.
Properties
- Color (Properties)
- Physical Form
- Cured Properties
Value Units Test Method / Conditions Impact Resistance (on steel) 20 ft.lbs/in² - Lap Shear Strength (as rec'd CRS) 2340 psi - Hardness 75.0 - Shore D Adhesive Testing (on plastics, PVC, ABS glass filled nylon, stirene) Substrate failure - - Thermal Service Range -65 - 260 °F - Chemical Resistance Excellent - - Elongation 60.0 % - Peel Strength (on Aluminum) 20 - 25 psi - Lap Shear Strength (Aluminum) 3390.0 psi - Lap Shear Strength (Grit blasted steel) 3365 psi - Typical Film Thickness 0.03 inches - - Uncured Properties
Value Units Test Method / Conditions Viscosity (Mixed, at 25°C) 50000 cPs - Flash Point 51.0 °F Cleveland open cup Toxicity Moderate - - Solvents None - - Mix Ratio 1 : 1 - - Fillers Yes - - Specific Gravity (at 20/20°C) 1.01 - - Clean Up Solvents MEK, Acetone - -
Packaging & Availability
- Country Availability
- Packaging Type
- Regional Availability
- Packaging Information
Side-by-side cartridges.
Storage & Handling
- Shelf Life
- 12 Months
- Storage & Shelf Life
Store in an unopened original container in a cool, dark area between 55°F to 75°F. Shelf Life is 12 months