ProSpec® Concrete Resurfacer

•  Apply when air or substrate temperature is between 50°F (10°C) and 100°F (38°C). For applications outside this range of temperatures, contact ProSpec Technical Services.
•  Concrete Resurfacer should only be applied to a properly prepared substrate. Remove any material that interferes with bond including dust and dirt by brooming and vacuuming.
•  Pour the mixed Concrete Resurfacer onto the substrate. Then spread with a squeegee, or flat trowel using enough pressure to assure good contact with the entire surface then broom finish.
•  Expansion joints should be marked to prevent being filled with Concrete Resurfacer. Work in areas small enough for easy access for broom finishing without having to walk on the fresh Concrete Resurfacer. A broom finish needs to be applied within 10 - 15 minutes of application while the product is still fresh.
•  Pour subsequent applications while the previous application is still wet.
•  On vertical installations such as stairs, trowel Concrete Resurfacer directly onto the properly prepared distressed area and finish as desired, less water may be required.
•  Concrete Resurfacer can be applied at a thickness of up to 1/2” and accept foot traffic after 2 hours, and rubber wheel traffic after 8 hours at 70oF (21oC).
•  Not intended to match the color of the concrete being repaired.

Test results obtained under controlled laboratory conditions at 73°F (22.7°C) and 50% relative humidity unless otherwise specified. Tested using 4 qt (3.8 L) water per 50 lb (22.7 kg) powder. Reasonable variations can be expected due to atmospheric and job site conditions.

This product is available in;
Gray: 50 lb (22.7 kg) bag - Product #65510461

Shelf life of this product is six months from the date of manufacture when stored in the original, unopened container, away from moisture, under cool, dry conditions and out of direct sunlight.