Enhanced TDS
Identification & Functionality
Features & Benefits
- Labeling Claims
- Ready-to-Use Product Features
- Product Features
- Excellent adhesion and high strength
- Excellent bonding to porous & non-porous surfaces
- Quick drying and setting time
- Excellent heat resistance
- Low odor
Applications & Uses
- Application Area
- Application Method
- Compatible Substrates & Surfaces
- Cure Method
- Product Applications
- MAGIK 555 LV is specially developed for bonding applications of nitrile rubber insulation material, flexible elastomeric and closed cell foam insulation.
- MAGIK 555 LV will make a resilient and heat resistant bond with many materials where use of low VOC solvent-based rubber based adhesive is suitable and required.
- Application Procedure
The surface should be structurally sound, clean, dry, leveled, unheated and free from dust, curing compounds, grease and other loose debris. Keep container closed when not in use.
Brush or roll a thin even coat of Magik 555 LV on both surfaces to be joined. Allow the adhesive films to become dry to the touch, but tacky, before joining the surfaces. Press the two surfaces together. Be sure the insulation is in the desired position before the adhesive surfaces make initial contact, since the adhesive forms an instant bond, and repositioning after contact is difficult. Moderate pressure should then be applied to the entire bonding area to insure complete contact.
Note: The adhesive and the parts to be bonded must be at room temperature for optimum results (do not use below 10°C). The final bonding strength will depend on the pressure applied. Therefore, press across the entire surface as firmly as possible. Make sure that there is no water or moisture penetration within 48 hours of adhesive application with the substrate and that the substrate is free of condensation.
Properties
- Physical Form
- Appearance
- Black Liquid
- Specifications
Value Units Test Method / Conditions Specific Gravity 0.83 - 0.93 kg/ltr ASTM D 1475-98 Solid Content 26 - 30 % ASTM D 1644 Viscosity 300 - 600 cPs ASTM D 2196 Drying Time (Set to Touch) 5 - 10 min. ASTM D 1640 Service Temperature (Temperature at surface) - 20 - 100 °C - Coverage Range (subject to surface condition) 5 - 6 m2/ltr - - Product Properties
Coverage Range (subject to surface condition): Wet coverages shown below are for smooth non-porous surfaces. Porous or rough surfaces may require more consumption.
Regulatory & Compliance
- Quality Standards
Packaging & Availability
- Regional Availability
- Packaging Information
2.5 Ltr Rectangular Metal Can
Storage & Handling
- Shelf Life
- 12 months
- Storage Conditions
- 12 months from date of manufacturing in original unopened containers.
- Store product (10°C - 35°C) for maximum storage life. Higher temperatures reduce normal storage life.
- Lower temperatures may cause increased viscosity of a temporary nature.
- Rotate stock on a “first in-first out” basis.
- Failure to comply with the recommended storage conditions may result in premature deterioration of the product or packaging.