Enhanced TDS
Identification & Functionality
- Chemical Family
- Product Type
- Technologies
- Product Families
Features & Benefits
Applications & Uses
- Markets
- Applications
- Application Area
- Application Method
- Application Guidelines
Surface Preparation
- Surfaces must be free of dust, dirt, oil, grease, and moisture to ensure proper adhesion.
Application
- PD2128D can be applied by spray, roll coat, or brush application.
Coverage
- Coverage rates depend on the porosity of the substrates and method of application.
Fiberglass Insulation:
- Spray the adhesive on one side of fiberglass insulation at a coverage of 3 – 6 grams wet/ft².
- Allow 30 to 60 seconds depending on temperature and humidity.
- Attach to steel or aluminum surface using hand pressure only.
Mineral Wool to Itself:
- Spray the adhesive to both surfaces.
- Allow 30 to 60 seconds depending on temperature and humidity.
- Combine with hand pressure.
- Mineral wool failure should occur once the water has completely dissipated (depends on temperature and humidity).
Fiberglass Facing Material to Mineral Wool and Fiberglass Insulation:
- Spray or roll coat the adhesive onto the facing material.
- Within 30 – 60 seconds, combine the facing to mineral wool or fiberglass insulation using light pressure.
- Spray / Pump Equipment Recommendations
- Graco, Binks, and DeVilbiss HVLP hand guns.
- Pressure Feed Systems are recommended for best control to achieve the desired delivery rate and spray pattern.
- The adhesive can be dispensed into the spray guns in several ways:
- Pressure Pot: Stainless steel or plastic liner; intake tube must be stainless steel.
- Pumping Equipment: Double Action diaphragm pump, Graco Husky 1040.
- Gravity Feed: Feed from 300-gallon tote bin positioned on an elevated tower.
- Cleanup Procedures
When still wet, use warm soapy water For dry adhesive removal: MEK, isopropyl alcohol, or “environmentaly safe” solvents such as Citrex (Inland Technology)
Properties
- Color (Properties)
- Technical Data
Value Units Test Method / Conditions Density 8.6 lb-mass/gal - pH 3.5 - 4.5 - - Solid Content (Non-Volatiles) 54 - 58 % - Viscosity 200 - 1,100 cP - - HVLP Starting Recommendations
HVLP Starting Recommendations
Type Fluid Nozzle Fluid Nozzle Fluid Pressure Atomization Pressure
Graco 239542 239592 239592 5-10 psi 30-50 psi Binks BBR 20 20 5-10 psi 30-50 psi DeVilbiss JGA 510 FX FX 5-10 psi 30-50 psi
Regulatory & Compliance
- Certifications & Compliance
Packaging & Availability
- Regional Availability
Storage & Handling
- Shelf Life
- 1 year
- Storage Conditions
- Protect from freezing
- Storage temperatures between 60-85°F
- No special handling instructions due to toxicity. This product contains limited amounts of residual monomer.
- Under normal handling and use conditions the residual monomer should not present a hazard. In storage, the monomer will migrate from the emulsion and establish an equilibrium between the headspace in the storage container and the liquid emulsion.
- Levels in excess of acceptable exposures can accumulate in non-vented headspaces above the emulsion. All procedures appropriate for a confined space entry should be completed prior to performing any work in a bulk storage tank.
- 12 months from date of manufacture when stored in original, unopened container at recommended temperature conditions.