Foster® Fire Resistive Anti-Abrasion Coating 30-16

• Fire resistive anti-abrasion coating meets requirements for leed 2009 ieq 4.2 low-emitting materials, paints and coatings.
• Nuclear grade fire resistive anti-abrasion coating 30-16q can be supplied to meet the stress corrosion and chemical analysis requirements of nuclear regulatory guide 1.36 on special order.

Material preparation

• stir well.
• Do not thin.
• Apply only to clean, dry, oil-free surfaces.
• Keep container closed when not in use to prevent surface skinning.

Application

• Apply at 100 – 150 sq. Ft./gal. (2.5 – 3.7 m2 /l) to clean, dry, inner surface or bore of cellular glass insulation.
• Allow to dry before installing insulation.

Brush

• Use clean paintbrushes (suitable for water-based paints).
• Apply in a single, heavy, full, brush coat at recommended coverage.
• Avoid crisscross brushing.

Spray

• 30-16 can be applied using a variety of spray equipment.
• For spray equipment information, please contact your spray equipment supplier.
• Average viscosity range: 20,000 – 30,000 cps.
• Before using for the first time, existing spray systems must be completely cleaned and free of the old coatings and solvents.
• Corrosion resistant pumps and fittings are suggested.

To clean up, use warm, soapy water if still wet. When dry, use mineral spirits (flammable) or chlorinated solvent (non-flammable).

• Store and apply between 40°F (4°C) and 100°F (38°C), protect from freezing until dry.
• Remove product from metal piping or other pieces of insulation while it is still wet.